From Status page, you can view the current status of your access point and its features.
Name: The name of the access point.
Firmware:The current firmware version on your access point.
Boot loader:The boot loader version that is running on your access point.
Method: The security method for your access point. This information can be configured from the Wireless section of the Security page.
Encryption: The encryption type for your access point. This information can be configured from the Wireless section of the Security page.
Pass phrase: The Pass phrase or Key for your access point. This information can be configured from the Wireless section of the Security page.
Wireless MAC filter: Displays whether the wireless MAC Filter status is Disabled, Allow, or Deny. This information can be configured from the MAC Filter section of the Security page.
Network name: The Network name of the access point that is broadcast for wireless connections. This can be configured from the Wireless page.
Broadcast name: Whether the broadcasting of the network name is Enabled or Disabled. This can be configured from the Wireless page.
MAC address: The wireless (WLAN) MAC address of the access point.
WDS restrictions: The status of WDS restrictions on the access point, either Enabled or Disabled.
IP address: The IP address that your access point uses on the LAN.
Subnet mask: The LAN interface Subnet Mask of your access point.
MAC address: The MAC address of your access point.
Note: Any devices connected to the access point that have static IP addresses will not show up in the Clients list.
MAC Address: The MAC address of the client.
Association Time: The time since the client last associated with the access point.
Authorised: If the client is authorised to connect to this access point, the status will display as Yes. If the client is not authorised to connect to the networking device or , the status will display as No.
WMM Link: If the client supports WMM, the status displays Yes. If the client does not support WMM, the status displays No.
Power Save: If the client is running in Power Save mode, the status displays Yes. If the client is not in Power Save mode, the status displays No.