The Wireless MAXg Detection Utility is not locating the Bridge
to which I want to connect.
Possible Solution:
Verify that all the physical connections of the Bridge are securely
connected.
Possible Solution:
Click Detect to rescan the network.
Possible Solution:
If the Bridge to which you want to connect is not located after you
click Detect, perform the following steps:
- The networking device (e.g. router or access point) that the Bridge is connected
to probably has some form of Web User Interface where you can view a client
list. Perform the neccesary steps to view this client list in your networking
device. Refer to your networking device's documentation to determine how to
view this information.
- Locate the Bridge in the client list by verifying the LAN MAC address that
is on the bottom label of the Bridge and what appears in the client list.
Write down the IP address of the Bridge for future reference.
- Open a Web browser, type in the IP address of the Bridge, and then press
Enter. This will open the Web User Interface of the Bridge. Verify that all
the connection information is correct for the network to which the Bridge
is connected.
Return to Troubleshooting page