The Wireless MAXg Detection Utility is not locating the Range Extender
to which I want to connect.
Possible Solution:
Verify that all the physical connections of the Range Extender are securely
connected.
Possible Solution:
Click Detect to rescan the network.
Possible Solution:
If the Range Extender to which you want to connect is not located after you
click Detect, perform the following steps:
- The networking device that the Range Extender is connected to probably has
some form of Web User Interface where you can view a client list. Perform
the neccesary steps to view this client list in your networking device. Refer
to your networking device's documentation to determine how to view this information.
- Locate the Range Extender in the client list by verifying the LAN MAC address
that is on the bottom label of the Range Extender and what appears in the
client list. Write down the IP address of the Range Extender for future reference.
- Open a Web browser, type in the IP address of the Range Extender, and then
press Enter. This will open the Web User Interface of the Range Extender.
Verify that all the connection information is correct for the network to which
the Range Extender is connected.
Return to Troubleshooting page