Assistenza


Questa pagina č predisposta per la stampa. Per stampare questo documento, clicca sul tasto stampa della barra del tuo browser. Al termine, clicca sul tasto chiudi, situato in alto a destra o in fondo alla pagina, per chiudere la finestra e tornare alla pagina precedente.


Configuring Your Broadband Router for use with Analog Modems


  1. Connect your serial cable to your analog modem and to the COM port on the broadband router. Make sure the modem is powered on.

  2. Go to the Configuration Utility and click Primary Setup. Click Change and select the WAN type as Dialup Network.

  3. In the Buad Rate field, select the setting 115200 from the drop-down box for maximum throughput capabilities.

  4. In the Extra Settings field, insert AT&F1.

  5. Click Save and reboot the broadband router. Click Dial-up to initiate a dial-up session with your ISP. The peripheral status will display whether or not the call was successful. If the settings are correct, the analog modem will connect to the Internet. If you cannot connect to the Internet, verify you have entered all the correct values in the Primary Setup page before connecting to the Internet again.

    6. Note: For specific terms and definitions, access the Analog Glossary for more information.

     

Queste FAQ (Domande Frequenti) ti sono state d’aiuto? (1 = nessun aiuto, 5 = grande aiuto)
1   2   3   4   5  
 
Ti hanno permesso di risolvere il problema?
Si   No   Non so (non ho ancora provato)  
 
Commento facoltativo (255 caratteri al massimo)

Chiudi finestra