I am unable to communicate with the 22 Mbps Wireless Access Point.
Possible Solution:
Be sure that each Wireless PC Card, PCI Adapter, or PCI Adapter (with
detachable antenna) that you want to connect to the wireless network is
set to Infrastructure mode within the Configuration Utility. If
your 22 Mbps Wireless PC Cards or PCI Adapters are not set to Infrastructure
mode, they will not be able to communicate with the 22 Mbps Wireless Access
Point.
Possible Solution:
Your 22 Mbps Wireless Access Point may not be responding. Try resetting
the 22 Mbps Wireless Access Point to reactivate it. Press in and hold
the RESET button. While holding in the RESET button, unplug the power
adapter from the 22 Mbps Wireless Access Point and then plug it back in.
Continue to hold the RESET button for about five seconds to restore the
factory default settings. When this is performed, the Wireless Activity
LED will blink.
Possible Solution:
Be certain the 22 Mbps Wireless Access Point has the correct IP address
for your LAN. Check the listed IP address for the 22 Mbps Wireless Access
Point in the Configuration Utility.
|