Support


This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.


My 10/100 Ethernet Switch is properly connected to my Ethernet-ready device, but my connection speed is slow.

Possible Solution:
Verify that your network adapter and/or additional Ethernet-ready device supports 100 Mbps. You may be using a 10 Mbps device. To achieve 100 Mbps speeds, replace any 10 Mbps devices you are using with 100 Mbps devices.

Possible Solution:
Verify you are using a known and reliable RJ-45 Category 5 Ethernet cable. An old or unreliable RJ-45 Category Ethernet cable could diminish your link quality. It may be necessary to replace your RJ-45 Category 5 Ethernet cable.

Possible Solution:
Check the LED status lights on your 10/100 Ethernet Switch. A flashing yellow light indicates you are receiving and transmitting data at 10 Mbps. A flashing green light indicates you are receiving and transmitting data at 100 Mbps. If you only see blinking LEDs, it may be necessary to replace your RJ-45 Category 5 Ethernet cable.

Possible Solution:
The length of your Ethernet cable between your 10/100 Ethernet Switch and your workstation or computer should not exceed 328 feet. Some power sources with strong electromagnetic fields may be causing interference.

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
 
Did it resolve your problem?
Yes Yes   No   Not sure (haven't tried it yet)  
 
Additional Comments (255 characters maximum)

Close Window