Support


This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.


Problem: I cannot print to a network printer attached to my USR9107 ADSL2+ 4-Port Router in Windows XP/2000.

Possible Solution:

Ensure that your printer is installed correctly and powered on.

Possible Solution:

Check that your printer has sufficient ink and paper. A printer connected to the print server cannot send its status to your computer.

Possible Solution:

Reboot the router by unplugging the power cord. Wait at least 30 seconds before plugging it in again. This will clear the print queue of any pending documents.

Possible Solution:

  1. Windows XP Users: Click Windows Start and then Printers and Faxes.

    2. Windows 2000 Users: Click Windows Start, Settings, and then Printers.

  2. Right-click on printer_name on http://192.168.1.1:1631 and click Properties.

  3. Click the Advanced tab, make sure that Enable advanced printing features is disabled, and then click Print Processor.

  4. For Default data type, select RAW, and click OK.

  5. Click Apply, then click OK.

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
 
Did it resolve your problem?
Yes Yes   No   Not sure (haven't tried it yet)  
 
Additional Comments (255 characters maximum)

Close Window