Support


This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.


Accessing the Web Interface

Possible Solution:
If the USR8700 is powered on and then connected to your network, the device will not acquire an IP address via DHCP. The solution is to power off the device by pushing the power button and releasing it. After the device shuts down, simply push the power button to re-start the device after you have hooked it up to your network. In Windows XP, it is also helpful to have UPnP enabled as this will notify the user when the USR8700 is actively on the network and accessable.

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
 
Did it resolve your problem?
Yes Yes   No   Not sure (haven't tried it yet)  
 
Additional Comments (255 characters maximum)

Close Window