This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.

How to set up a printer with USR808700:

Connect the printer to the USR808700 (Serial ATA 4-Drive NAS) by using a USB cable. The product immediately recognizes the new peripheral device just connected; the fact that USB led is turned off is correct. In order to check that the printer has been correctly connected, you can go to the 8700 user interface, then click on advanced and then on USB (see images). All the devices connected by a USB cable will then be shown on this page.

choose advanced choose usb

To set up the printer and verify if it is really connected to the local network, please follow these instructions:

  1. In windows explorer click on My Network Places
  2. click on Entire Network
  3. select Microsoft Windows Network
  4. select the network to which the 8700 is connected
  5. select the 8700 (enter user/password)
  6. select the printer from window on the right; once you have accessed the configuration page (of the same printer), select the drivers you may need to make it work properly.

connect to lan

After having executed the previous steps, the printer is ready for use.

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
 
Did it resolve your problem?
Yes Yes   No   Not sure (haven't tried it yet)  
 
Additional Comments (255 characters maximum)

Close Window