This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.

Configuring Your Broadband Router for use with the ISDN Pro TA

  1. Connect your serial cable to your ISDN Pro TA Modem and to the COM port on the broadband router. Make sure the modem is powered on.
  2. Go to the Configuration Utility and click Primary Setup. Click Change and select the WAN type as Dialup Network.
  3. Enter the appropriate information for your ISDN connection. In the Extra Settings field, refer to the table below for the appropriate setting:
  4. ProtocolString
    PPP_128K most commonly usedAT*VI=0*VO=5*PPP=3S67=0

    Note: Contact your Internet Service Provider (ISP) for your specific protocol or access the Glossary for protocol definitions.

  5. In the Buad Rate field, select the setting 230400 from the drop-down box for maximum throughput capabilities.
  6. Click Save and reboot the broadband router. Click Dial-up to initiate a dial-up session with your ISP. The peripheral status will display whether or not the call was successful. If the settings are correct, the ISDN Pro TA Modem will connect to the Internet. If you cannot connect to the Internet, verify you have entered all the correct values in the Primary Setup page before connecting to the Internet again.

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
Did it resolve your problem?
Yes Yes   No   Not sure (haven't tried it yet)  
Additional Comments (255 characters maximum)

Close Window