Support


This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.


The 22 Mbps Wireless PC Card, PCI Adapter, or PCI Adapter (with detachable antenna) cannot communicate with other computers linked via Ethernet in the Infrastructure configuration.

Possible Solution:

•Ensure that each computer in the wireless network is powered on.
•Ensure that each 22 Mbps Wireless PC Card, PCI Adapter, or PCI Adapter (with detachable antenna) is configured on the same operating radio channel. If the IDs are different, change each 22 Mbps Wireless PC Card, PCI Adapter, or PCI Adapter (with detachable antenna) within the LAN to the new radio channel.
•Ensure that each 22 Mbps Wireless PC Card, PCI Adapter, PCI Adapter (with detachable antenna) is configured with the same security options.
•Ensure that you can connect to the Wireless Access Point and that the BSSID shows the MAC address of the Wireless Access Point you want to communicate with.
•Ensure that you have a valid IP address for the network you are trying to connect to.
•Ensure TCP/IP is installed. Ensure you are a part of the same domain or workgroup. Ensure that you are automatically obtaining the IP address or that you have a correct IP address and subnet mask. Reset the Wireless Access Point and restart the computer that has a connectivity issue.
Ensure that you have some files available for sharing.
•If you are not using a USRobotics Wireless Access Point, ensure that you can connect to the Access Point and that the preamble mode is set to Long .

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
 
Did it resolve your problem?
Yes Yes   No   Not sure (haven't tried it yet)  
 
Additional Comments (255 characters maximum)

Close Window