Support


This page has been designed for printability. To print this document, click the Print button on your browser's toolbar. When you are finished, click the Close Window button located at the upper-right or bottom of the page to close this window and return to the previous page.

How do I allow only certain IP addresses access to Local Servers in order to make my USR8200 even more secure?

To increase your security control to prevent Internet users from accessing your Intranet or local servers, you can configure your USR8200 to grant or deny specific IP addresses. To do so, follow the steps below:

  1. Define the Local Server as demonstrated in the graphic below:

  2. Select the Advance Filtering tab.
  3. Click the LAN Ethernet Rules link within the Output Rule Sets section.
  4. Create the allowed connections
    5. .
  5. Create the Drop rule.

    6. Note: The Drop All Packet rule must be listed last based on the destination IP address you are securing.

 

Was this FAQ helpful? (1 = not helpful, 5 = very helpful)
1   2   3   4   5  
 
Did it resolve your problem?
Yes Yes   No   Not sure (haven't tried it yet)  
 
Additional Comments (255 characters maximum)

Close Window