Contents:

Connecting to your ISP

Using the AT Command Set

Upgrading your Modem

Modes of Operation

Dialing, Answering, and Hanging Up

Working with Memory

Controlling Result Code Displays

Controlling EIA-232 Signaling

Accessing and Configuring the Courier 56K Corporate Modem Remotely

Controlling Data Rates

Dial Security

Flow Control

Handshaking, Error Control, Data Compression, and Throughput

Displaying Querying and Help Screens

Testing the Connection

Dedicated/Lease Line and Synchronous Applications

Troubleshooting

Appendixes

S-Registers

Alphabetic Command Summary

Flow Control Template

Result Code Meanings and Sets

Technical Information

V.25 bis Reference

ASCII Chart

Fax Information for Programmers

Viewing LEDs

Regulatory Information

Glossary

 

Courier 56K Corporate Modem Command Reference

Controlling Result Code Displays

This chapter contains information about:

Result Code Display Commands

The commands listed below control whether result codes are displayed, and in what format they are displayed.

If you want the modem to
Command
Display result codes.
ATQ0
NOT display result codes.
ATQ1
NOT display result codes while in Answer mode. See the Modes of Operation chapter in this guide for a description of modes.
ATQ2
Display result codes in numeric form.
ATV0
Display result codes in verbal form.
ATV1
Display result codes when originating, answering, and retaining a call.
ATS14.1=0
Display result codes ONLY when originating a call.
ATS14.1=1
Display sets of result codes. Refer to the Result Code Meanings and Sets appendix in this guide.

ATXn
(Default ATX7)

Note: For all Courier 56K Corporate modems, except the PC card version, DIP switch 3 overrides the Qn setting, DIP switch 2 overrides Vn setting, and DIP switch 7 overrides the S14.1=n setting.

 

Additional Result Code Subsets

Note: ARQ (Automatic Repeat Request) is used in this manual to denote calls that use error control.

For your modem to
Command

NOT display ARQ result codes. This setting pertains only to the display of codes and not to ARQ function.
AT&A0

Display ARQ result codes. If the Courier 56K Corporate modem is set to X0 and the connection rate is 1200 bps-56 Kbps, a result code is displayed.
AT&A1
Display modulation indicators (HST, V32, VFC, V34, or DIGITAL). If your software cannot handle the added modulation information, select &A1 or &A0.
AT&A2
Display error control (LAPM, HST, MNP, or NONE) and data- compression type (V42 bis, MNP5) indicators.
AT&A3 (Default)

Note: The numeric identifiers for &A3 result codes are the same as those used for &A2. If you request numeric display (V0) and &A3, you won’t be able to distinguish &A2 from &A3 codes. Also, &A3 result codes may not be compatible with some software.