Contents:
About the 802.11g Wireless
Gaming Adapter and Ethernet Bridge
Installation
Accessing the Web User Interface and Site Survey
What is Wireless Networking?
Web User Interface and Security Configuration
Troubleshooting and Support
Regulatory Information>
USRobotics
Corporation Limited Warranty
|
802.11g Wireless
Gaming Adapter and Ethernet Bridge User Guide
Regulatory Approvals
FCC Declaration of Conformity
These devices comply with FCC Rules Part 15. Operation is subject
to the following two conditions: These devices may not cause harmful interference.
These devices must accept any interference received, including interference
that may cause undesired operation. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy.
If this equipment is not installed and used in accordance with the manufacturer's
instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The use of shielded cables for connection of the monitor to the graphics
card is required to assure compliance with FCC regulations. Modifications
to these devices not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
Detachable Antenna Information
FCC Part 15, Subpart C, Section 15.203 Antenna requirement 5430 users:
An intentional radiator shall be designed to ensure that no antenna other
than that furnished by the responsible party shall be used with the device.
The use of a permanently attached antenna or of an antenna that uses a
unique coupling to the intentional radiator shall be considered sufficient
to comply with the provisions of this section. The manufacturer may design
the unit so that a broken antenna can be replaced by the user, but the
use of a standard antenna jack or electrical connector is prohibited.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated
with minimum distance 20 cm between the radiator and your body.
Industry Canada Statement
The term "IC" before the radio certification number only signifies that
Industry Canada Technical specifications were met. This equipment complies
with the Industry Canada Spectrum Management and Telecommunications policy,
RSS-210 standard, Low Power License-Exempt Radio Communication Devices.
Operation is subject to the following two conditions:
- This device may cause interference.
- This device must accept any interference, including interference that
may cause undesired operation of the device. To reduce potential radio
interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotopically radiated power(EIRP) is not
more than required for successful communication. This device has been
designed to operate with an antenna having a maximum gain of 2dB. Antenna
having a higher gain is strictly prohibited per regulations of Industry
Canada. The required antenna impedance is 50 ohms.
UL Listing/CUL Listing
For external devices: This information technology equipment is UL-Listed
and CUL-Listed for the uses described in the users guide.
For internal devices: This information technology is UL-Listed and CUL-Listed
for use with UL-Listed personal computers that have a users guide detailing
user installation of card accessories.
|
CE Declaration of Conformity
|
We, USRobotics Corporation of 935 National Parkway, Schaumburg, Illinois,
60173-5157,USA, declare under our sole responsibility that the USRobotics
802.11g Wireless Gaming Adapter and Ethernet Bridge, 5430 to which this
declaration relates is in conformity with the following standards and/or
other normative documents:
EN300 328-2
EN301 489-1
EN301 489-17
EN50371
EN60950
This equipment is in compliance with the European recommendation 1999/519/ECC,
governing the exposure to the electromagnetic radiation.
We, USRobotics Corporation, hereby declare that this product is in
compliance with the essential requirements and other relevant provisions
of Directive 1999/5/EC. This product can be used in the following countries:
Ireland, Greece, Germany, Austria, Belgium, Switzerland, Netherlands,
Luxembourg, Italy, France, UK, Portugal, Sweden, Norway, Denmark, Finland,
Spain, Czech Republic, and Hungary.
Regarding IEEE 802.11g we currently have the following information about
restrictions in the R&TTE countries:
Country |
Frequency band |
max. output power |
France |
2454-2483.5 MHz |
10 mW EIRP outdoor |
Operating Channels:
IEEE 802.11g compliant
11 channels (U.S., Canada)
13 channels (ETSI)
14 channels (Japan)
Regulatory Channel Frequency
|
Channel
|
Frequency (MHz)
|
FCC
|
Canada
|
ETSI
|
Japan
|
1
|
2412
|
X
|
X
|
X
|
X
|
2
|
2417
|
X
|
X
|
X
|
X
|
3
|
2422
|
X
|
X
|
X
|
X
|
4
|
2427
|
X
|
X
|
X
|
X
|
5
|
2432
|
X
|
X
|
X
|
X
|
6
|
2437
|
X
|
X
|
X
|
X
|
7
|
2442
|
X
|
X
|
X
|
X
|
8
|
2447
|
X
|
X
|
X
|
X
|
9
|
2452
|
X
|
X
|
X
|
X
|
10
|
2457
|
X
|
X
|
X
|
X
|
11
|
2465
|
X
|
X
|
X
|
X
|
12
|
2467
|
|
|
X
|
X
|
13
|
2472
|
|
|
X
|
X
|
14
|
2484
|
|
|
|
X
|
Go to www.usr.com to see the most recent channel restriction information.
EU Health Protection
This device complies with the European requirements governing exposure
to electromagnetic radiation. This equipment should be installed and operated
with minimum distance 20 cm between the radiator and your body. This wireless
device is a transmitter/receiver and has been designed and manufactured
to comply with the exposure limits recommended by the Council of the European
Union and the International Commission on Non-Ionizing Radiation Protection
(ICNIRP, 1999) for the entire population. The exposure standard for portable
equipment uses the "Specific Absorption Rate" as unit of measure. The
maximum SAR value of this wireless device measured in the conformity test
is 0.19 W/kg.
EU Detachable Antenna Information
This USR wireless device has been designed to operate with the antenna
included in this package only. Together this device and antenna combination
has been tested and approved by a European Agency conforming with the
European R&TTE directive 1999/5/EC to meet the radiated power level requirement
of 100mW e.i.r.p. Replacement of this antenna must only be done with an
authorized USR component that has been designed and tested with the unit
to the requirements of directive 1999/5/EC. Please refer to the USR web
site to get product antenna ordering information.
Manufacturer's Disclaimer Statement
The information in this document is subject to change without notice and
does not represent a commitment on the part of the vendor. No warranty
or representation, either expressed or implied, is made with respect to
the quality, accuracy or fitness for any particular purpose of this document.
The manufacturer reserves the right to make changes to the content of
this document and/or the products associated with it at any time without
obligation to notify any person or organisation of such changes. In no
event will the manufacturer be liable for direct, indirect, special, incidental
or consequential damages arising out of the use or inability to use this
product or documentation, even if advised of the possibility of such damages.
This document contains materials protected by copyright. All rights are
reserved. No part of this manual may be reproduced or transmitted in any
form, by any means or for any purpose without expressed written consent
of its authors. Product names appearing in this document are mentioned
for identification purchases only. All trademarks, product names or brand
names appearing in this document are registered property of their respective
owners.
|